Tuesday, 31 December 2013

USING THE LUTTERLOH SYSTEM

using the lutterloh system

Its such a huge relief that the lutterloh system is finally in Africa and I am the sole marketer right here in Nigeria. It was really a dream come true

Tuesday, 24 December 2013

COME SEW LUTTERLOH WITH ME

How do I sew my garments together once the pattern is made?
Are you completely new to sewing?


Make one of the aprons or something that is easy and hasn't too many pieces to figure out.
What is in your Lutterloh pattern book that has only a few pieces?

Beginning sewing is taught in most fabric stores so I won't cover that
(check our links on the right for sewing help),http://bit.ly/1fVhAfc,

what I will cover is


"How to sew together a Lutterlor  pattern


I like Nancy Ziemans ideas for starting a sewing project. It helps to brake up your sewing time into little snatches. We are all so busy I find this format the best for me.


I do these steps in little bits until I'm all finished!


I learned so sew in high school without instructions so a step by step list is very helpful. I will add mine for pants to start you thinking.

FIRST
1)
Look over the pattern. Did you make each piece?
a. Lay the paper patterns together as they would fit and see if all are fitting together OK.
Walk sleeves into armscyes etc.

2) Did you make facings (or change them to update?)

3) Cut out the fashion fabric adding seam allowance and hems.

4) Is there a lining and did you cut it out? Did you need to cut out facings, iron on or sew in?
Once all this is finished you are ready for the sewing steps.

WARNING: you must add seam allowances and hems on all Lutterloh patterns before cutting.



Facings:
Facings are shown on the pattern with the hatch marks as below and an ST written in the area. Some hatch marks work as interfacing some tell us to roll the fabric around for a self finish. It may surprise you that you will often make the choice as to what way you use a facing mark.


You can trace, with see-through paper, the area for a pattern piece labeled facing. Can you find the facings in the patterns below? I would leave my finished pattern taped to my table and lay a 2nd piece of paper over the area with facing marks and trace them. Some have measurements you can just cut from.





I see facings on the coat front only. The front and back and on the pant waist band would be interfacing in my thinking. The hatch marks on the knit top are just turned under facings Another point of interest is the two piece sleeve. See the one cross but two arrows? Draw it as one, cut it as two. It is a coat after all and the sleeve are usually two pieces. See anything I missed?

*************************************************
The next step
ORGANIZE
1. Did you pre-treat your fabric

2. Do you have your scissors, pattern weights, rulers for seams, thread, buttons, zippers, hemming materials etc. I dump them into a plastic box or bag. Keep it on hand for the project.
3. Mark your pattern pieces for the darts, the hems, buttons, etc. You may like to mark with chalk on the wrong side or you might use pins. What ever marking method works best for you. Before I cut out fabric I will often put a safety pin on each piece to show the front of the fabric.
4. Test and apply fusible interfacing.
5. Set up your machine for sewing.
6. Sew facings and linings, this includes iron in facings


WARNING: you must add your seam allowances to everything! I prefer 1/2 seams use what ever works for you. Don't forget your hems

Once all the facings are in you can proceed to the step by step part
let's do pants first because I think they are the hardest to do.
******************************************************
Pants
1) do everything you can do while the pants are flat
a. sew darts, press toward the center
b. put in pockets, put in belt loops
c. put in zipper
d. press hems (yes on each piece)


2) Put the pant pieces together
a. Stitch the side seams front to back
b. Stitch the inner leg seams front to back, press seams allowances toward the back.
c. Sew the crotch curve from the center back at the waist to the zipper opening

3) Waist and Hems
a. Fold the hem and sew using what ever technique you wish
b. Make and sew in waist band, or turn waist band for elastic use. Pattern notes elastic, otherwise use a faced band.
c. add waist snap, hooks, or sew close opening for elastic.
Press everything and if you have a trouser you will have pressed the center fold before sewing.
All done!
It's just that easy.


 - A few details I tend to forget when sewing without directions:
1.stay stitch curved pattern pieces after cutting to avoid stretching of the bias
2.clip curves and grade seam allowances before pressing facings
3.under stitch facings and secure to seam allowances to keep them from rolling outward

Monday, 23 December 2013

Lutterloh System - The Golden Rule

Lutterloh Pattern Making System: I absolutely adore this pattern making system. Unlike computerized ones, you don't need a computer to use it. If your computer breaks down or you lose your power, you won't be able to see any of the fashions, let alone make any patterns. With the Lutterloh system, you'll always have patterns ready to make anytime, anywhere!

You only need 2 measurements: bust and hip. That's it! Computerized pattern making systems require many measurements. Then you have to print the patterns out in sections and tape them together like a puzzle. Why spend all that time doing that when you could be sewing?

With the Lutterloh way of doing this, it takes only minutes to make a pattern, in one piece, using only 2 measurements and if your size changes, you won't have to go out and buy a whole new pattern! You can make patterns to fit you, your friends and your family!

Another wonderful thing about it is that if you have to make any adjustments to any part of a single pattern, then that same adjustment gets transferred to all the patterns since they're all based on the same mathematical formula. This alone has saved me hours of pattern alterations that I normally would have to make with regular commercial patterns since all of them are different. I can't say enough about this product, I just love it!

New! ---> Lutterloh Fashion Slide Show


View the Lutterloh fashions found in their catalog! Make any of these fashions for anyone! One pattern, any size! Can you imagine what it would cost to buy all these patterns separately, even if you collected them over several years like I used to do? Even if you bought these many commercial patterns for .99 each, you'd still come out ahead!

Check out Frank Lutterloh's Video about this fantastic product which shows you how this system works:www.sewing-nigeria.com

 
Get this system at the Lutterloh Pattern Making System Web Page.lutterloh pattern making system

Sunday, 22 December 2013

WELCOMETO THE LUTTERLOH SYSTEM

Designed by Jide Ogunsanya.